Re: A guide to fixing/troubleshooting some common plasma TV problems
I have a Visio P50HDTV that lost the picture (still has sound). No pop of death, just went out. It has new power supply (for a turn on problem) and Y-Sus and upper and lower driver.
Before changing the Y it would have a soft glow in the middle of the screen with fuzzy edges and approx. 10" almost square.
After the Y change it has a vertical bar approx. 10 inches that is bright with what looks like the retrace lines one would see on tube type TVs, but these are vertical, not horizontal. The bar goes from the top of the screen to the bottom.
If I unplug the Z-sus it returns to the fuzzy box in the middle of the screen.
Does that sound like the Z is also bad, or some other issue?
Thanks,
Kenneth
I have a Visio P50HDTV that lost the picture (still has sound). No pop of death, just went out. It has new power supply (for a turn on problem) and Y-Sus and upper and lower driver.
Before changing the Y it would have a soft glow in the middle of the screen with fuzzy edges and approx. 10" almost square.
After the Y change it has a vertical bar approx. 10 inches that is bright with what looks like the retrace lines one would see on tube type TVs, but these are vertical, not horizontal. The bar goes from the top of the screen to the bottom.
If I unplug the Z-sus it returns to the fuzzy box in the middle of the screen.
Does that sound like the Z is also bad, or some other issue?
Thanks,
Kenneth
Comment