Re: CyberPower 1350AVR - Repair
Yes! My 1350AVR same problem, same repair, C1 22uf 50V. I actually ordered C1, C3 and C6 as well as the Viper chip, but, while waiting for them to arrive, checked ESR on the caps. C1 was bad, C3 & C6 good. Pulled C1 - it measured 460 nF instead of 22 uF. Substituted a 22 uF 160V (no 22uF 50V on hand).
Had to solder on wires (and heat shrink) and lay the cap on the board elsewhere as its diameter is bigger than a 50v same value cap. Works fine now. (If I had the other caps would have replaced them, too.) With thanks to those who posted the solution here! Ed
Originally posted by RETUSNET
View Post
Had to solder on wires (and heat shrink) and lay the cap on the board elsewhere as its diameter is bigger than a 50v same value cap. Works fine now. (If I had the other caps would have replaced them, too.) With thanks to those who posted the solution here! Ed
Comment