hi,
can someone clean me?
backup bios and ec T440p VILTZ2 NM-A131 Rev:1.0 win8
can someone clean me?
backup bios and ec T440p VILTZ2 NM-A131 Rev:1.0 win8
-
Hello everyone,
I’m currently working on a dead MSI GP75 Leopard (MS-17E71) motherboard (i7 CPU, NVIDIA GPU) with a no display/no backlight issue initially. After extensive investigation, I’m at a critical stage involving EC firmware, BIOS/ME region interaction, and possible deep corruption. I'm seeking advanced insight from anyone with experience in EC/BIOS sync issues or PCH-level behavior. Here’s a full breakdown:
🧩 Initial Issue- Board powers on (fans spin, keyboard lights up and can be adjusted, caps lock led lights), but no display or backlight
- External display (HDMI) shows
07-24-2025, 02:17 PM -
As per the the rules, here are the specifications of my laptop :- Make and model number : Thinkpad T440P
- Serial number (S/N) : PB-03A7V7
- Model type - Model (MTM) : 20AW-S2N800
- Bios version : 2.50 (not 100% sure, that's what I remember)
- Upgrade screen, keyboard, trackpad, RAM and CPU
- Reboot and use the laptop for a bit : everything is working fine
- Shutdown (no power) and upgrade WIFI with unsupported chip (AX210)
- Boot up the device : bios warning, as expected
- Shutdown the device again (no power)
- Connect the 8-pin clip of a CH341a
-
Hello everyone,
I am requesting urgent assistance to unbrick my laptop, a rebranded TongFang GK7MRFR chassis. The laptop is completely dead following a faulty in-OS EC flash attempt.
I have successfully used a CH341A programmer and can read/write/verify both flash chips, but using my backups/extractions has failed to restore power. The root cause is likely a corrupted Intel Management Engine (ME) region or an incompatible EC/BIOS pairing. System & Hardware Details- Barebone / Chassis: TongFang GK7MRFR
- MB: MB: GK5MP5X V1.0 Prod :GK5MRFV10T04201310281
- Rebrand: PC Specialist
-
Hello everyone,
I recently bought a non-working Asus Zenbook Pro Duo OLED UX8402ZA that was listed for parts only. The seller mentioned that it had no display output but that the charging lights worked.
When the laptop arrived (without a charger and SSD), I connected a charger and confirmed with a multimeter that it was charging the battery. However, when I tried to power it on, only the backlight of the secondary display came on. There was no image, and it didn’t boot into the BIOS.
I decided to try flashing a new BIOS, but since I didn’t want to desolder... -
First of all thanks to all of our members who have posted previously all methods posted here.
Please leave a comment if you find something new,or have anything else to add.
-----------------------------------------------------------------------------------------
Find by serial number,model number or series
If you know the laptop serial or model number go to HP support https://support.hp.com/us-en/drivers/laptops .
Enter the serial number or model number and click submit.On the next screen you will have to enter the OS
Operating system and OS version.If...