thanks 1.8 adapter i must use
when i try to read with adapter 1.8 and clip pomona 8pin i steel get error chip id
i must desolder to check
doyou have bios bin ?
Problem with acer is i have red light and when i press power blink only
Keyboard is ok
With battery out i dont have any light
I have 6volt on motherboard battery 2 Pins
I make dicharge with button (swg2)
Bios chip no voltage
Last edited by george_gpu; 12-27-2019, 12:07 PM.
Reason: Forget
Problem with acer is i have red light and when i press power blink only
Keyboard is ok
With battery out i dont have any light
I have 6volt on motherboard battery 2 Pins
I make dicharge with button (swg2)
Bios chip no voltage
Check page 32 of the schematic,SWG1 BI SW ,battery in switch,it has to be pressed in for the battery to charge.It presses in when the case is screwed down.
Desolder the bios,then see your programmer will read it.Post your bios backup if it does.If you don`t have 1.8V on pin 8 check schematic to find 1.8VALW voltage.
Thank you very much mcplslg123, you just had to open the original file and see if it uses one or another bios file, it served me perfectly, it is a misleading device, because seeing that it turns on without giving video makes a novice technician think that it is a problem with the GPU RYSEN and it is actually Corrupt BIOS problem.
Last edited by piernov; 11-04-2020, 03:32 AM.
Reason: google translate
Comment