plz someone remove whitelist from lenovo t540p
-
​Hello, this is a BIOS file for the Lenovo X270 laptop, read out through a CH341 programmer. I located error 1802 in the PE32 module. This is a detection for the network card's whitelist. How can I bypass or remove the whitelist check? My skills are limited, and I have tried many times but ended up with a black screen. How can I normally bypass this whitelist check? Please help me edit this BIOS file, thank you. It would be great if you could provide illustrations to guide me. Thank you very much!... -
This specification for the Lenovo ThinkPad T540p Grade Barga1n+ Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the T540p Grade Barga1n+ boardview and T540p Grade Barga1n+ schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification,...09-06-2024, 09:01 AM
-
hello can you please remove wifi whitelist from lenovo T440 . Thank you in advance... -
Long story short. i am building a fully custom car radio. and want to use a extremely bright LCD.
sadly the DGPU seems to be nonfunctional after i fixed the bios (fried voltage controller). so the Original HDMI port does not work.
you can use a EDP TO HDMI adapter to add a HDMI port as replacement to the onboard EDP LCD connector,
HOWEVER it turns out. lenovo enforces a LCD whitelist.
this means you cannot upgrade the LCD despite matching EDP specs and voltages.
If i connect a new screen directly to the system. only static shows.... -
Hi,
I want to remove the Bios Password of my Lenovo IdeaPad U330p with the Lenovo autopatcher. I have the CH341A Black and I'm using NeoProgrammer. The Programmer has an LED that indecates when it reads or writes the Chip. When I try to Connect my Programmer to the Bios Chip (Winbond 25Q64FVSIQ) the LED lights up even though I didn't click on Detect botton in NeoProgrammer. If i click on Detect the LED still remains on and NeoProgrammer says "IC not responding".
SN: QB08570065
MB: DA0LZ5MB8D0; REV: D; MODEL J31/N02