asus gl703gs it8225 dead?

[myth77]

i have this laptop from the title that pch was dead, replaced it. Then figured POWER SW. SN1409049DPUR also shorted and it8171fn shorted. replace them...
Now the board when power inserted is showing white power light but nothing is hapenning. I figured that from power SW. SN1409049DPUR i have this reading:
3vsus 3,2vol
3va_dsw 3,2vol
+3va 3,2vol
but +3va_ec only 1,7vol

So i replaced power sw. SN1409049DPUR but same thing..but then i noticed when power brick inserted for a split second i have 3,2 v on +3va_ec but then it drops to 1,7v. So i removed it8225 and without it8225 i have +3vol on +3va_Ec but when i soldered it8225 back again i have 1,7v on +3va_Ec .
So, is it8225 dead? i dont have new one so i have to order couple of them but just wont to make sure that problem is coming from there? any thoughts?

[mon2]

Re: asus gl703gs it8225 dead?

Are you confident that the replacement is being soldered in the same orientation of pin #1 of the component?

[myth77]

Re: asus gl703gs it8225 dead?

yes

[mon2]

Re: asus gl703gs it8225 dead?

Remove all power. Measure the resistance to ground of this power rail. Are there any caps on this same rail?

Remove them as one or more may be shorted.

When the rail sinks to this lower voltage, does this iTE controller get very warm or hot? It should if it is at fault.

[myth77]

Re: asus gl703gs it8225 dead?

Remove all power. Measure the resistance to ground of this power rail. Are there any caps on this same rail?

Remove them as one or more may be shorted.

When the rail sinks to this lower voltage, does this iTE controller get very warm or hot? It should if it is at fault.

there are caps but line is not shorted to gnd. Ite controller is not getting hot..I believe the resistors are fine but i will double check. I also attached schematic.