Hi,
Replaced a broken screen, everything went fine. The Surface connected to the internet, downloaded lots of updates, started updating (touch working fine at that point).
Display driver installed, all good, touch ok.
Then it went to installing Firmware and after completing the touch was gone. No touch in the UEFI area too, was fine before the upgrade.
Things I've tried so far:
reinstalling drivers,
reinstalling Windows, both with clean install and official image.
Is there a way to get the touch back without de-soldering the BIOS chip?
Thanks!
Replaced a broken screen, everything went fine. The Surface connected to the internet, downloaded lots of updates, started updating (touch working fine at that point).
Display driver installed, all good, touch ok.
Then it went to installing Firmware and after completing the touch was gone. No touch in the UEFI area too, was fine before the upgrade.
Things I've tried so far:
reinstalling drivers,
reinstalling Windows, both with clean install and official image.
Is there a way to get the touch back without de-soldering the BIOS chip?
Thanks!