Runs on Intel HD Graphics like evil 
Attached Files
-
Last edited by kropotkin; 05-30-2020, 06:30 PM. -
Re: Inventec DAKAR DK10FG DIS to UMA
thanks
in addition to the mainboard model, please mention the model of the laptop too. -
Re: Inventec DAKAR DK10FG DIS to UMA
There is one mistake - bootstrap capacitor on 2-nd picture left to 2R2 0603 resistor under TPS51601 must be 0.1uF intead of 0.022 uF. Model of laptop is Toshiba L855 or some...
Also I remove 216-0833000 from desk, did not try with chip on board.Last edited by kropotkin; 06-10-2020, 01:01 PM.Comment
-
Re: Inventec DAKAR DK10FG DIS to UMA
thank you it's working but i have problem, after driver is stock on windows logo can you help meComment
-
Re: Inventec DAKAR DK10FG DIS to UMA
Sorry for late reply, all was done according to schematics and boardview, everything was working
Is voltage on +VGFXCore coil present?Attached FilesLast edited by kropotkin; 11-12-2020, 02:20 PM.Comment
-
-
Re: Inventec DAKAR DK10FG DIS to UMA
I need more detailed information on how to do it, can you help?Comment
-
Conversion Discreta a UMA Toshiba L850 Intel ⭕ 6050A2509901-A02
https://www.youtube.com/watch?v=9XbqJTs-4fI
Comment
-
HP X360 14-DW Inventec LAIKA-6050A3202801-MB-A02
... -
Hi there,
I have a DK10FG-6050A2491301-MB-A03 motherboard with missing ACOK voltage. Here are the basic voltages of BQ24725A. The motherboard is dead with no signs of life.
ACN : 19.35V
ACP : 19.36V
ACDET : 2.7V
REGN : 5.916V
VCC : 19.36V
Diode mode to ground reading on ACOK rail is 0.450V on pin 1 of R6013 and 0.230V at pin 2. Replaced BQ24725A a couple of times. Still no luck.
The problem was that I was not having 3.3V/5V from the TPS51225 regulator. So I tracked down to the BQ24725A which was missing the ACOK voltage... -
Here to help.
Firmware for Inventec AMD R5-3500U 6050A3044201-MB-A01
U365
U366
U401
I hope this helps the forum or someone....05-31-2024, 09:42 AM -
HP EliteBook 830 G6
Inventec CATALONIA 6050A3022401-MB-A01 schematic... -
Inventec PS10S 6050A2170201-MB-A03 boardview...
Comment