hello
i got myself a fujitsu AH532 intel board with everything integrated
wires on dc jack were ripped so i soldered it
first time i pressed power on everything blinked laptop turned on, image was there, all ok
after assembling would not give image... num lock and hdd led blinks twice charging led stays on, fan spins but no image. fan stops after a while, cou gets little warm...
i reflowd pch hm76 , same, no change
then i flashed bios... it has 3 eproms 1mb, 2mb, 4mb... 2mb eprom was dead, could not write it, always error so i change it with same sst 25q16bv and all stays the same
any help or guide???
i got myself a fujitsu AH532 intel board with everything integrated
wires on dc jack were ripped so i soldered it
first time i pressed power on everything blinked laptop turned on, image was there, all ok
after assembling would not give image... num lock and hdd led blinks twice charging led stays on, fan spins but no image. fan stops after a while, cou gets little warm...
i reflowd pch hm76 , same, no change
then i flashed bios... it has 3 eproms 1mb, 2mb, 4mb... 2mb eprom was dead, could not write it, always error so i change it with same sst 25q16bv and all stays the same
any help or guide???
Comment