liquid was spilled. i cleaned board.
i checked coils for short and everything looks ok.
i connected a usb tester to check voltage and Amps. The tester shows 20V at 0.08A which is too low.
on board i do have 12.6v, 3.3v but not the 5v S5 stage.
No any other voltages are present.Am i suppose to have more voltages!
where do i go next.
Thanks
i checked coils for short and everything looks ok.
i connected a usb tester to check voltage and Amps. The tester shows 20V at 0.08A which is too low.
on board i do have 12.6v, 3.3v but not the 5v S5 stage.
No any other voltages are present.Am i suppose to have more voltages!
where do i go next.
Thanks