Lenovo IPad 320-15IKB eDP failure

[the Benninger]

Specifically I enter with the connector very damaged, from another service it did not start correctly, I redid the BIOS now it turns on normal, it only generates image through the HDMI port it does not generate image in the display which I already discarded by placing the eDP cable and the LCD new

a cut in a track 14 jumping it with a small piece of cable can you see
MoBo is NM-B242 Rev 1.0

I leave photos and readings of the 30 pins that I made with the multimeter, thank you very much for those who can extend their hand

[mcplslg123]

+LCDVDD_CON is missing. Check voltages on pin 1/4/5 of U5.

[the Benninger]

thanks for taking interest @mcpisig123, I located the U5 transistor I took a picture and added the values of the measurement, it is curious but I did not find datashett of this component

[the Benninger]

hey mcplslg123 Could you help me the signal that appears on the pin one appears for a brief moment when the computer starts then it is lost, it marks zero after a couple of seconds, just in case you know who sends the signal to activate if you are so kind as to indicate

[mcplslg123]

Check Resistance to GND on pin1(without power)
If the reistance is High on pin1, jumper between pin5 and pin1 of U5(component still being removed).
Try again.

[the Benninger]

resistance to GND to pin 1 is 173k hom, I did the bypass as you indicated and the screen worked again I thank you for the help this equipment had given me many problems it was very damaged
I appreciate the time you took to indicate the solution I hope it multiplies by a thousand in equipment that you receive to repair -thanks u

[mcplslg123]

Happy to know it helped you and thanks for your good wishes.