I just test on a working board (yes I have 3 of then to repair the first one), the prochot is always low. Is it normal ? Not used ?
To resume :
1. I bought a dead laptop (full) with no vcore
2. I bought another full dead laptop that I repaired (short circuit on wlan card because antenna connectors were broken). Fully fonctionnal under windows
3. I bought another dead logic board. This one has all voltages during few seconds but secondary voltages loop (1.2v, 0.95v, 1v, vcore). Only 5v, 3.3v, 1.8v are stable. I took the ISL chip from this one to put one #1 with no result so I soldered back to #3
To resume :
1. I bought a dead laptop (full) with no vcore
2. I bought another full dead laptop that I repaired (short circuit on wlan card because antenna connectors were broken). Fully fonctionnal under windows
3. I bought another dead logic board. This one has all voltages during few seconds but secondary voltages loop (1.2v, 0.95v, 1v, vcore). Only 5v, 3.3v, 1.8v are stable. I took the ISL chip from this one to put one #1 with no result so I soldered back to #3
Comment