there two way to solve you problem. soft and hard. Soft way first check Ram,Proccesor and video chip last bios. For the last step you need a Bios programmer. Hard way you have to check all voltage rails.
there two way to solve you problem. soft and hard. Soft way first check Ram,Proccesor and video chip last bios. For the last step you need a Bios programmer. Hard way you have to check all voltage rails.
thanks for your sharing i was found must be 1.5 VP on schematic but that is 8 volt is that failure consumtion voltage on PL 401 ?
pq401
pin 5 6 7 8 = 18.5 volts
pin 1 2 3 = 1.8 vols
you have to check 18.5 rail for a shortcircut
i was check for pq401 if power on
pin 5 6 7 8 = 18.5 volt
but
pin 1 2 3 = 10.9 volt
pin 4 = 10.6 volt
i was check for pq401 if power of
pin 5 6 7 8 = 18.5 volt
but
pin 1 2 3 = 0 volt
pin 4 = 0 volt
Do you have on pin 4,10 ,+5ALWAY ?. Pin 1 EN .. this signal from I/O EC controller enabled PU 401 if all of is correct. Check EC controller voltage and bios
Do you have on pin 4,10 ,+5ALWAY ?. Pin 1 EN .. this signal from I/O EC controller enabled PU 401 if all of is correct. Check EC controller voltage and bios
Comment