HUH! the problem is that it wont keep bios settings date/time and i already change the bios battery..and it surely have 3,2 volts,whats the prob??can it be the bios??help needed.
just check your wiring from your CMOS battery, make sure the red is + and Black is Negative, Wrap your CMOS with electric tape tight enough to connect both wire in your cmos
Cant do any better picture than this one..so theres an arrow on the female connector which means positive and the readings are right 3,21+ and when i set the bios right and take the powercord off and wait approx 1 min they are again in 0..so should i keep the main battery on..newer heard that kind of lappie..
Ok,but still eather way i do it its the same.... ...and talking about cold solder joints im been in (fla) fixing too mutch ,and thats not the point thats why i found this page.So gurus i need help .
Comment