acer Aspire 5610 fan problems

[amirbassim]

Hello, dear people

Any idea please about the problems of cooling fan, don't run, the laptop works fine but the fan stopped all time, and when installing windows, the laptop shoot down in the end of installation

thanks

[momaka]

Re: acer Aspire 5610 fan problems

Have you tried cleaning the fan and make sure that it spins freely?

[amirbassim]

Re: acer Aspire 5610 fan problems

hello

thanks for your replay

the fan is clean qnd works fine in another aspire 5610

there is not voltage in the fan connectorm it s this the problem

[momaka]

Re: acer Aspire 5610 fan problems

Look for any burned components such as MOSFETs near the fan connector.

It would also be very helpful if you post a good picture of the main board where the fan connector is. Use the "Manage Attachments" option (in the forum's advanced text editor) to attach your pictures rather than posting them off-site (such as imageshack, photobucket, etc.). Picture size restrictions are 2000x2000 pixels, but that should be enough.

[fddizon]

Re: acer Aspire 5610 fan problems

trace back the wire of the fan....

or you can remove fan connector and jump on +5volts of a usb supply.


just a thought

[amirbassim]

Re: acer Aspire 5610 fan problems

thanks for your replay

the other problem in this laptop is not charging battery!

in the same laptop aspire 5610, the battery is charging very well!

mosfet problems, surely!???

[momaka]

Re: acer Aspire 5610 fan problems

mosfet problems, surely!???

Either that or in some cases the battery/power management chip (usually Maxim or Intersil).

[amirbassim]

Re: acer Aspire 5610 fan problems

thanks, friends

I think that the problems is with mosfets

there are 3 mosfets: 2 Si4810 BDIy and 1 AO4407

I think that is here the problem?

how to verify?

[momaka]

Re: acer Aspire 5610 fan problems

Get their data sheets and check with multimeter for low resistance/short circuit between Source and Drain. If there is, remove MOSFET from the board, touch all of its pins with your finger (this is done to discharge the Gate), then test it again. If MOSFET is still shorted, then it's bad.
There's also numerous articles online how to check MOSFETs. Just make note of what type your MOSFET is (i.e. N-type/NMOS or P-type/PMOS).