Msi b250m bazooka shutdown after few seconds

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • rex98
    Badcaps Legend
    • Feb 2023
    • 1273
    • Mandaue CEBU, Philippines
    #1

    Msi b250m bazooka shutdown after few seconds

    Does anyone here encountered the same problem i have on this motherboard? It shutdown after few seconds PCH is hot. The bios is fine. All voltage signals are normal it just shutsdown when it turned on a few seconds like 30sec the logo shows up ang bios settings shows the pch heats up then shutsdown itself. Can someone help me. I need schematics and boardview of this motherboard.
    Attached Files
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • sew333
      Pc shutdown, monitor flickered with no signal after 10 seconds
      by sew333
      My pc:
      10850K stock 4800mhz stock Kraken X73 good temps
      2x16 GB DDR4 GSKILL 3000mhz XMP
      Seasonic Tx-850 Ultra Titanium
      Gigabyte Rtx 3090 Gaming OC
      Aorus Z490 Pro Gaming
      1 TB SSD


      4 weeks ago i launched Metro Exodus Enhanced and during cinematic advertisement part ( 30 fps ), pc just shutdown.
      Also monitor flickered with NO SIGNAL 10 seconds after shutdown. So only monitor and pc was affected.

      Next i pressed only power button, rebooted again and its fine again. Happened once and i cant reproduce.


      Power...
      02-22-2022, 10:27 AM
    • DrFalken
      Dell Inspiron 5593 shutdown after 5 seconds
      by DrFalken
      Hello everyone!
      Motherboard model: FDI55 LA-J081P
      Today a customer delivered this laptop completely dead, with the original power supply shorting when plugged into the connector.
      I found and replaced a shorted MOSFET (PQZ3).
      Now the laptop turns on (fan runs fine but no video signal) and after 5 seconds it turns off.
      BIOS has already been updated (both 64MB and 128MB IC)

      +3VALW and +5VALW are still present.
      +VCCIN = 1.8V stable (measured on PLZ1 at power up)

      Abnormal readings:
      PLZ1 to GND = 0 Ohm
      PLZ2 to GND = 0 Ohm
      ...
      04-09-2025, 10:45 AM
    • Pygo86
      Liyama G-Master GB3466WQSU-B1 - Backlight on - Shutdown after a few Seconds
      by Pygo86
      Hey Folks,

      i'm not far into Monitor troubleshooting. It's my first time. Normaly i try to repair Laptops.
      The Monitor is powering up. And the Backlight turns on. After a few Seconds the Backlight shuts off and the Power LED turns form Blue to Red.
      I can power it up again, but it's always the same Result.
      No Matter which Connection is used.

      I can't see anything obvius after disassembling. No Heatspots with the Thermalcam visible.
      The Powerboard is looking great. There is 12V and 5V everywhere on the Logicboard.
      So, i decided to swap that Logicboard....
      3 Photos
      03-04-2024, 11:38 AM
    • johnbeton
      Aspire A315-56 LA-J801P shutdown after 4 seconds
      by johnbeton
      Hello,

      I have a Aspire A315-56 with a LA-J801P mainboard.
      After liquid damage, the system did not power on at all. After replacing PR509 (499K Ohm - ENLDO_5V) the powerled goes on for 4 seconds, then shutsoff. No image.

      Anyone an idea what to check next ?
      Thanks in advance
      05-08-2023, 01:33 PM
    • ravi_1617
      Sony MBX-223 ,M971 , Shutdown after 40 seconds
      by ravi_1617
      Hi.! This Sony board turns off after 40-42 seconds.
      (with adaptor/battery or both)
      Don't turn on until 20 seconds,
      If I disconnect Power immediately when off,than I can turn on, than again stays on same time, aprox 40 seconds

      Did changed ,
      thermal paste, CPU.
      Flashed bios also.
      fan heatsink also clean
      Before turning off fan also turns on.
      Any points I am missing
      Thanks
      08-31-2021, 11:42 PM
    • Loading...
    • No more items.
    Working...