Hello i need an information have a Zotax Gtx 1070 8Gb Mini with two missing capacitors
are C389 and C3235 i need a value
thanks
are C389 and C3235 i need a value
thanks
-
Last edited by maxlab; 06-03-2021, 04:23 AM.
-
Hi, last night my zotac 1070 mini blew off a capacitor. I've had a look and identified it to be C336 capacitor and maybe the R005 resistor. Does anyone have any idea what kind of replacement capacitor I need to get to fix it or any boardview schematics for the card?... -
Title:
Capacitor detached from PCB – RTX 2070 Super Founders Edition
Description:
During maintenance on an RTX 2070 SUPER Founders Edition, I found a capacitor lying on my desk after reassembly.
I did not notice it detaching, so I am unsure of its original location on the PCB.
Procedure performed:
- Removed backplate
- Cleaned heatsink and PCB with isopropyl alcohol + soft ESD brush
- Reapplied thermal compound
- Reassembled card
Observed behavior after reassembly:
- GPU powers on and operates normally under... -
I have surface go 2 that a capacitor was nocked off. Can anyone tell me the value of the missing capacitor or if it's needed.
Motherboard# DA0Z93MBAE0...09-12-2025, 10:16 AM -
Hi,
I have an RTX 2080 ti (Zotac - triple fan) with no video output.
So far I have measured the following:- PS_FBVDD_PH3_SW = 40 ohm to ground (Micron ICs) - Memory should be fine right?
- 12V power rail present
- 3.3V power rail present
- 5V power rail present
- 1.8V power rail present
- Vcore power rail missing --> PS_NVVDD_VREF is present. (from uP9512P / U812)
- Vmem power rail missing --> Not there because Vcore power rail is missing.
Any idea? I have already tried to flash the BIOS chip (backup got created) - sadly no changes.
Source: https://www.techp... -
looking for schematic/board view for Zotac 1070 mini, 8GB...
also.. if someone could post here the most clear photos
that i can zoom in on of the front and the back of the Zotac 1070 mini..
that is what i really need.... but a board view would be helpful...
On the contrary.. really clear crisp pictures of the back and front of the ZOTAC 1070 mini..
that is what would help the most for me in my case...
i had removed a few resistors from it to use on another GPU.. but i seem to have forgotten the locations of where i took them off... ...06-10-2022, 06:24 PM