Re: Vox mini 3 amp
Hi Ben7,
I didn't want to complicate the board more than needed although I suppose you only have to click a button on the CAD software, also I didn't want too much exposed area of copper that might touch anything. As both speaker leads are at half the rail voltage the likelihood of a possible short to ground would destroy the chip.
Soldering was done by hot air gun so not sure if you count that as hand soldering?
Midibob
Hi Ben7,
I didn't want to complicate the board more than needed although I suppose you only have to click a button on the CAD software, also I didn't want too much exposed area of copper that might touch anything. As both speaker leads are at half the rail voltage the likelihood of a possible short to ground would destroy the chip.
Soldering was done by hot air gun so not sure if you count that as hand soldering?
Midibob
Comment