Finding Short Circut Ohm value

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • shvanahmad61
    Member
    • Dec 2022
    • 11
    • sulaymanyah

    #1

    Finding Short Circut Ohm value

    Hi guys I see alot of technican who works on laptop Motherboard while Testing mosfet and Caps they use Ohm mode instead of continuity Mode , i need the right values to test mosfet and caps Thanks

Related Topics

Collapse

  • aaronkatrini
    DELL Nvidia GTX 750Ti Mosfet goes short after a few minutes
    by aaronkatrini
    Hi all,

    I have recently picked up this Dell OEM Nvidia GTX 750Ti 2GB Video card. Its an old card I know but still wanted to get it working if possible. The problem is the following:

    - Put the card in my testing motherboard and start running Heaven benchmark
    - Benchmarks seems to run smoothly up until half way then the motherboard completely shuts off immediately
    - Try to start it again and I get a slight move from the PSU fan - a clear short
    - A little troubleshooting later I find one shorted Mosfet - Replace them both - short is gone
    - Put the...
    05-18-2025, 04:18 PM
  • jm942
    Hp Lh482p 5 short 3 long short after cpu vcore mosfet replacement
    by jm942
    Hi,
    My laptop went dead and after checking ,the main 19 volt power rail was shorted. After some checks i could identify that a high side vcore mosfet was shorted.
    I replaced the mosfet and now the white powerled is present , fans start spinning but capslock shows the famous 5 long and 3 short code.

    I checked the vcore voltages after replacement and i get for all 1.01 V so means for me that the driver is still working of the replaced shorted mosfet. On the Nvidia i measure around 0.8 V after the mosfets.
    I did voltage injection on the cpu with 0.7V and i have a current...
    07-11-2024, 05:11 AM
  • joshAU
    Acer AN515-55-528T FH52M LA-J891P - Short ciruit after PQW1 MOSFET on +1.35VSDGPU rail.
    by joshAU
    Hi all.
    This notebook was showing no signs of life.

    I removed the FH52M LA-J891P mainboard and found that there was 19V at the DC jack.
    However there was zero volts on the two PRB2 and PRB46 resistors immediately after the two polarity protection MOSFETs (PQB11 & PQB12).

    If I remove the PQW1 MOSFET, the 19V rail starts working, and I can turn on the unit - at least I get the fans, and the power light comes on, when I simulate the power button being pressed. No display.

    I tried replacing the MOSFET with a new one, but again no voltage on the...
    05-29-2024, 12:33 AM
  • dqtech
    Asus X455L Short Mosfet
    by dqtech
    I got this laptop from friend with problem short 19v....when i check this 2 mosfet getting short...i remove that mosfet and confirm that mosfet is short...



    and check that 2 capacitor PC9009 and PC9004 pad is also short...already check where that capacitor goes and came from but cannot find the main problem...please help

    ...
    08-09-2022, 08:53 PM
  • Jane
    How do you test MOSFET in laptops ?
    by Jane
    I tried to use this method:

    Testing an N-channel MOSFET:

    Step 1: Discharge the Gate (turn off the MOSFET)
    Place the black probe (COM) on the Source (S) and the red probe on the Drain (D). The multimeter should show no continuity (high resistance or "OL" – open line).
    Then, touch the black probe to the Source (S) and the red probe to the Gate (G). This discharges any stored charge in the Gate, turning the MOSFET off.

    Step 2: Charge the Gate (turn on the MOSFET)
    Now, place the red probe on the Gate (G) and the black probe on the
    ...
    09-27-2024, 03:31 AM
  • Loading...
  • No more items.
Working...