Re: Signal Tracer - Requesting input on requirements
While I was removing and testing caps, I found that the resistor after the amp and before the speaker had broken off. Very subtle, I had looked over it before and not seen it. So, volume has been restored, the speaker sounds pretty good. Tomorrow, I'm going to try out tuning the gain with my newly arrived 2k rev audio taper pot.
While I was removing and testing caps, I found that the resistor after the amp and before the speaker had broken off. Very subtle, I had looked over it before and not seen it. So, volume has been restored, the speaker sounds pretty good. Tomorrow, I'm going to try out tuning the gain with my newly arrived 2k rev audio taper pot.
Comment