Hi, my second post... i've opened a tv which i suspected in cold solderings,
but i've done a stuoid thing when discharging the big cap, i put the discharger in the wrong place, in the scheme below i marked C and D the right point for the Cap and A - B the wrong place i done.
<img src="http://web.tiscali.it/bps_impianti/schema%20Tv.GIF">
After that tv brokes and i can only say which measurements i've
done on the IC and the transistor and the correct values from
schematic sheet:
IC pins my measure scheme meas.
1 -41,x -41,2
2 222 0,3
3 303 268
4 9 0
5 -33 -33
the transis.
B 0 0
C 222 0,3
E 0 0
transistor and diodes are not short or open.. thankyou, bye...
but i've done a stuoid thing when discharging the big cap, i put the discharger in the wrong place, in the scheme below i marked C and D the right point for the Cap and A - B the wrong place i done.
<img src="http://web.tiscali.it/bps_impianti/schema%20Tv.GIF">
After that tv brokes and i can only say which measurements i've
done on the IC and the transistor and the correct values from
schematic sheet:
IC pins my measure scheme meas.
1 -41,x -41,2
2 222 0,3
3 303 268
4 9 0
5 -33 -33
the transis.
B 0 0
C 222 0,3
E 0 0
transistor and diodes are not short or open.. thankyou, bye...
Comment