I have picked up this receiver to repair it and re-sell it.
I don't know what caused this issue.
I have checked the final transistors and they are all good, so the issue it seems that is not a short in the amp area.
There is a 9 pin connector at the standby board and there I have the standby 3.3V and 10.5V for the CPU_ST_VCC, nothing else.
I don't get any reaction from the receiver when I turn it on.
To me it seems like the standby relay is not getting the command from the CPU.
I never had this type of issue, so I don't know what can I do next.
Any help would be appreciated.
SM is available, but is over 33MB. I have found it at elektrotanya.
I don't know what caused this issue.
I have checked the final transistors and they are all good, so the issue it seems that is not a short in the amp area.
There is a 9 pin connector at the standby board and there I have the standby 3.3V and 10.5V for the CPU_ST_VCC, nothing else.
I don't get any reaction from the receiver when I turn it on.
To me it seems like the standby relay is not getting the command from the CPU.
I never had this type of issue, so I don't know what can I do next.
Any help would be appreciated.
SM is available, but is over 33MB. I have found it at elektrotanya.
Comment