Embarassing as it may be but i already threw it in the trash can out of pure frustration of how i messed the pcb up. For what its worthi would really like to know what i did wrong with the copper braid, so that at the very least i can learn from my mistake.
When i tried to clean the pads with the copper braid, i put my iron to 350°C and started to wiggle at those pads but immediately the copper braid was kinda stuck and glued to the pads and when i finally removed it, the pads were gone too.
Of course, they exists Like the Pomona SOIC8 clip, but it isn't recommended to use them except you're always Checking for corruption after Reading the bin.
I Challenged this before and it isn't so nice to read a corrupt BIOS Out of the SPI FLASH without knowing it. Since then i'll either Check the Image or desolder it.
Comment