Pro-Logic Smart Battery charger

[kenwoodhf]

Hello all. This is probably a long shot but I am hoping someone out there can help me. I have a Pro-Logic PL2510 smart battery charger that doesn't work. It goes though its start up routine but will not display the proper batty voltage when a battery is connected. There is not allot of electronics on the board so I decided for the $3, I would replace the 3 integrated circuits. No change in operation. The MCU is a PIC18F25k22 and I was able to extract the HEX code and reinstall it into the new IC. There is a programming header on the circuit board. After experimenting putting in different voltages I come to the conclusion that the MCU is not calculating the voltage correctly. I called the manufacture for help but they said this is a throw away product and no support is available. I believe that the program has been corrupted, so what I am asking is if anyone out there who might have this model charger is willing to extract the hex code and send it to me? I am a hobbyist and this become a challenge for me. I can disassemble simple code programs but this is far to complicated for me to try.
Thanks Jan

[sam_sam_sam]

Re: Pro-Logic Smart Battery charger

You need to two things first

You need to post a picture of the front of the power board and then the back of the board

You also need to post pictures of any other boards that are in this unit front and back of these boards