Hi, I recently got a monitor that goes to a black screen after about two minutes. The backlight will remain on though. After some googling, I think the problem is resistor R810. I tested mine after reading advice of others having the same issue and mine along with 3 others in a line were bad. I'm wondering though, should I try and replace these with the same value resistors or will they go out again? Is there maybe a higher value I could use to help prevent the new ones burning out?
I don't know anything about circuit design but I can solder okay. I attached images of the problem resistors and a screenshot of the post because I can't find the thread for the life of me. Just looking for some advice, thanks!
I don't know anything about circuit design but I can solder okay. I attached images of the problem resistors and a screenshot of the post because I can't find the thread for the life of me. Just looking for some advice, thanks!
Comment