I have a 305T that I recapped for a screen distortion issue and then a no display with power indicator flashing.
I also used a hot air station to heat the Altera chip to reset it.
Upon completion of these two tasks, i have a great screen, but only at 1280 x 800 resolution.
I have looked for drivers for the monitor, evidently there are none, updated my video drivers (this monitor was working fine on the pc before the repair), i tested monitor on a second pc and still a no go, i swapped out the dual link dvi cable same condition. When i attempt to reset the resolution the monitor goes into a test mode i guess, of solid full screen alternating colors, red, blue, green black, gray and just repeats this until the timer expires and it reverts to the 1280 x 800 resolution. other than that the picture is better i think than it was when i picked the monitor up a year ago second hand.
Is this a condition of me over cooking the Altera chip, or is it suggested that i do a proper re balling of the chip?
I also used a hot air station to heat the Altera chip to reset it.
Upon completion of these two tasks, i have a great screen, but only at 1280 x 800 resolution.
I have looked for drivers for the monitor, evidently there are none, updated my video drivers (this monitor was working fine on the pc before the repair), i tested monitor on a second pc and still a no go, i swapped out the dual link dvi cable same condition. When i attempt to reset the resolution the monitor goes into a test mode i guess, of solid full screen alternating colors, red, blue, green black, gray and just repeats this until the timer expires and it reverts to the 1280 x 800 resolution. other than that the picture is better i think than it was when i picked the monitor up a year ago second hand.
Is this a condition of me over cooking the Altera chip, or is it suggested that i do a proper re balling of the chip?
Comment