Hi Merry Christmas
I have this board not starting ,not charging when arrived.
Found no power at source of 2nd mosfet Q503 AON7410 .on CRO i can see a spike (like mountain) every 1-2 seconds. Was approx 2-3 volts
so suspect short somewhere.
Didn't find any defective component in charging section ,but replaced BQ24735.
So bypassed 1st mosfet Q502 AON7200 ,Than applied power increased bench power starting from 0 volt @ 2 to 4volts Aps increased .50-1Amps.
Found Q568 AP4232 Heating, replaced it ,u529 TPS51219 too was heating .
should i replace and check ,or am i missing some thing to check
Thanks
I have this board not starting ,not charging when arrived.
Found no power at source of 2nd mosfet Q503 AON7410 .on CRO i can see a spike (like mountain) every 1-2 seconds. Was approx 2-3 volts
so suspect short somewhere.
Didn't find any defective component in charging section ,but replaced BQ24735.
So bypassed 1st mosfet Q502 AON7200 ,Than applied power increased bench power starting from 0 volt @ 2 to 4volts Aps increased .50-1Amps.
Found Q568 AP4232 Heating, replaced it ,u529 TPS51219 too was heating .
should i replace and check ,or am i missing some thing to check
Thanks