Mainboard ID: KAT10 LA-5251P Rev.1.0
Schematic: https://www.badcaps.net/forum/showthread.php?t=50452
Tried bios from https://www.badcaps.net/forum/showthread.php?t=50452 on post #7
Measuring DRAMRST# signal on pin30 of DDR slot it's only 0.26volt
On Q52, pin1 0.26v, pin2 3v, pin6 0.26v
Caps lock & num lock led blink slowly five times then off (not blinking)
changing ram module known good and without ram module will give same blinking code
all voltages present on this board
is the voltage on pin30 of ram slot correct?
please advice...
Schematic: https://www.badcaps.net/forum/showthread.php?t=50452
Tried bios from https://www.badcaps.net/forum/showthread.php?t=50452 on post #7
Measuring DRAMRST# signal on pin30 of DDR slot it's only 0.26volt
On Q52, pin1 0.26v, pin2 3v, pin6 0.26v
Caps lock & num lock led blink slowly five times then off (not blinking)
changing ram module known good and without ram module will give same blinking code
all voltages present on this board
is the voltage on pin30 of ram slot correct?
please advice...