It seems that I have also hardware issue.
I measured voltages and found that cpu ok, ram also 1v, bios chip gets 3v if powered on.
What is missing is VCCGFXCORE_I
So i checked the power supply that is PU404 output on PL406 and there were 0V. Then I checked PWM_1A with osilloscope that comes into the PU404 and it is 0v and when power is pressed it is stready 1v. Other power supply PWM-s jump up and down like PWM-s should.
VCCGFXCORE_I has resistance 7.3ohm.
Does the VCCGFXCORE_I need to be created on power up or later? What could I check?
I measured voltages and found that cpu ok, ram also 1v, bios chip gets 3v if powered on.
What is missing is VCCGFXCORE_I
So i checked the power supply that is PU404 output on PL406 and there were 0V. Then I checked PWM_1A with osilloscope that comes into the PU404 and it is 0v and when power is pressed it is stready 1v. Other power supply PWM-s jump up and down like PWM-s should.
VCCGFXCORE_I has resistance 7.3ohm.
Does the VCCGFXCORE_I need to be created on power up or later? What could I check?
Comment