Microsoft surface book 2 Lvds pins

[Tjaytony]

Hello everyone. So I have this surface book 2. The dock doesn't charge the screen side. And it doesn't detect the the gpu. I dissambled it. Realized a capacitor beside the gpu is shorted. Changed it, now it detects gpu.

On the lvds connector. There are burnt/corroded pins. I will post pictures for better descriptions and to ask my question better.

Since it's detecting gpu now. I will only be talking about the lvds issue.

[Tjaytony]

Re: Microsoft surface book 2 Lvds pins

The burnt pin is on both connectors, the side i marked on the pictures. So my plan is to remove the insulation of the red wire, which is the burnt/corroded side. So I can run a wire directly to where it's connected on the motherboard. The problem is that I dont know where I'm suppose to connect it to. Because there's no schematic or board view. And I have tried using the continuity test on multimeter to try and figure out where it's connecting to. But no luck.

So it's down to anyone who have access to the schematic, boardview or the scrap/bad motherboard at hand. Because that's the only way I would know where to connect the red wires to on the Motherboard.

I will also appreciate other ideas.

Note: I have detached/unsoldered the connectors. The trace are totally gone.

I will so much appreciate any help.

[Tjaytony]

Re: Microsoft surface book 2 Lvds pins

I realized I might not be getting any reply on this. Because it's not a common device that anyone could own. But if also anyone has a link to where I can buy surface book 2 1835 bad board. I could really use the help.