Hello everyone.
I took a chance and bought a dead asus tuf gaming 8gb 3060ti.
I have looked for shorts but the only rail that seems bad is pex at 4ohm. If I plug the card into a mining riser and no motherboard connection all the rails power up. I get 3.3v, 5v, 1.8v, 1v pex, 0.7v and 1.2v and they stay on and the core heats up. If I manually trigger the pex reset then all the rails turn off in a couple of seconds. What would cause this.
The card is also not detected when plugged into a motherboard.
I took a chance and bought a dead asus tuf gaming 8gb 3060ti.
I have looked for shorts but the only rail that seems bad is pex at 4ohm. If I plug the card into a mining riser and no motherboard connection all the rails power up. I get 3.3v, 5v, 1.8v, 1v pex, 0.7v and 1.2v and they stay on and the core heats up. If I manually trigger the pex reset then all the rails turn off in a couple of seconds. What would cause this.
The card is also not detected when plugged into a motherboard.
Comment