Announcement

Collapse
No announcement yet.

Samsung syncmaster 213t lcd Power/but no video or back lights.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Samsung syncmaster 213t lcd Power/but no video or back lights.

    Hello
    I have a Samsung Syncmaster 213t lcd that will power on (green LED light) but has no video or back lights. I put a flash light up to the screen and saw no video. I have opened the lcd and checked the caps on the inverter board with an ESR meter they all check out and also tried replacing caps just in case. What could be the problem with the lcd.

    I also have a Gateway 900g 19" lcd that I replaced a few caps to get it to power on. After I replaced the cap the lcd powered on and now the lcd shows wavie lines dancing across the screen. Tried replacing other caps on the power supply with no luck. Is this a capacitor problem or something else?

    please Feel free to E-mail me with any suggestions or answers I would greatly appreciate it Thanks

    Bobibsen@mail.com

    #2
    Re: Samsung syncmaster 213t lcd Power/but no video or back lights.

    Did anyone ever figure out what is the cause of the problems on the syncmaster 213t?

    Comment


      #3
      Re: Samsung syncmaster 213t lcd Power/but no video or back lights.

      Originally posted by bluto View Post
      Did anyone ever figure out what is the cause of the problems on the syncmaster 213t?
      Try checking two resistors on the back of pcb that could have shorted; R996 label 4701 and R968 labeled 104.

      Comment


        #4
        Re: Samsung syncmaster 213t lcd Power/but no video or back lights.

        Disregard the above post/reply, that was for a Toshiba board I mixed in... still working and looking for a cure for my 213T. Thank you

        Comment


          #5
          Re: Samsung syncmaster 213t lcd Power/but no video or back lights.

          See other thread: https://www.badcaps.net/forum/showth...highlight=213t

          I have some replacements for the AO4600, if you need them PM me.

          Comment

          Working...