looking for a schematic if anyone has one, found some burnt components want to figure out the right parts to order
-
First post -Intel NUC 10i5 -BXNUC10i5FNH not powering on -IC burnt- request for IC details/datasheetHi all,
I came across this very active forum with knowledgeable folks on electronic circuits and components, while google searching for the details of my burnt IC marked 7603 in Intel NUC board. I joined this forum today and this is my first post here.
I recently got an Intel NUC 10i5 and had installed Linux Mint and was using it for about a month when it died suddenly and did not power up after that.(Power Adaptor is ok). When I opened the NUC , there was a burnt IC marked 7603 (and ILCB in second line). I am unable to find the details/datasheet of this IC. I will be grateful if... -
Hello Everyone,
Hope everyone is enjoying their repairs at hand!.
I am looking forward to get the schematic of Denon remote control RC1156. Actually long time no use of the remote leaked the battery thereby corroding few parts as well as the tracks.
I was able to join few of them but the remote is still not working, so i am looking forward for your help, in case anyone understand the schematic or the remote circuit diagram and could me assist me in repairing it.
Please refer to the attached picture, i think the voltage divider is missing... -
Hi,
I've been searching for a schematic for a Denon UCD77 without any luck, can anyone help?
Thank you -
Hi people, I hope this is the correct spot to post this, I'm new to the forum.
I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.
I hope these photos make it clear which component I am referring to:
(yes, the soldering is a bit botched from removing the blown one, I know)
I have found the board schematic (attached), but there does not seem to be a boardview available. I have never... -
Hi everyone,
i've made a mistake due to haste.
I was soldering an HDMI male plug of a 15mt cable, while i forgot the other side connected to HDMI5 input of my Denon AVR-X2500H (that was off in standby, anyway).
During the soldering process, i've seen a little spark from a wire, when i was soldering it with my soldering iron tip.
After that, i've checked on the rear of the AV and I saw the HDMI5 male connected (the other side of the cable).
I've immediately disconnected it, but it was too late.
HDMI5 input is not working anymore, blank screen.
Fortunately...