Re: MS 7360 P35 Neo F V1
When you parallel caps the amps [er, ripple] is additive.
The ESR you figure out like parallel resistors.
http://www.1728.com/resistrs.htm
- Since there is only two and the same size it works to 1/2 anyway.
So, your math is right -IF- those were the original caps.
I'm not sure if OST has any other series with short caps like that or not.
You did raise ESR from .014 to .019.
Raising is the wrong direction although that's not a huge step.
[Sorry, I should have caught that sooner.]
The other little problem is you mounted the caps with long leads by laying them over which can raise ESR for the caps you did that with by as much as .010.
At least it's working for now.
If it starts getting flaky later on then slap some polymers in that bad boy!
.
When you parallel caps the amps [er, ripple] is additive.
The ESR you figure out like parallel resistors.
http://www.1728.com/resistrs.htm
- Since there is only two and the same size it works to 1/2 anyway.
So, your math is right -IF- those were the original caps.
I'm not sure if OST has any other series with short caps like that or not.
You did raise ESR from .014 to .019.
Raising is the wrong direction although that's not a huge step.
[Sorry, I should have caught that sooner.]
The other little problem is you mounted the caps with long leads by laying them over which can raise ESR for the caps you did that with by as much as .010.
At least it's working for now.
If it starts getting flaky later on then slap some polymers in that bad boy!
.
Comment