Gents,
Need a little help. Have Panasonic TX-P50U30B that is stuck in standby with red light on. No blinks. Switch on relay clicks but light stays red, Flickers if i use remote
However set will not start. Relays click once, after 40 seconds one long click or relays then 3 short clicks, this is repeating every 40 seconds so its trying to start Standby is at 4.95v on pin 6 of P6 on power supply sending 5 v to the A board Beyond that have 3.5v on pin 7 which i assume drives the lamp.
Tried the usual resets but nothing fault is same. Unsure if PSU board or A Board
Screen is blank no sound
Any help would be great or how standby works?
Thanks in advance
Need a little help. Have Panasonic TX-P50U30B that is stuck in standby with red light on. No blinks. Switch on relay clicks but light stays red, Flickers if i use remote
However set will not start. Relays click once, after 40 seconds one long click or relays then 3 short clicks, this is repeating every 40 seconds so its trying to start Standby is at 4.95v on pin 6 of P6 on power supply sending 5 v to the A board Beyond that have 3.5v on pin 7 which i assume drives the lamp.
Tried the usual resets but nothing fault is same. Unsure if PSU board or A Board
Screen is blank no sound
Any help would be great or how standby works?
Thanks in advance
Comment