Hi, I am trying to modify an old ATX power supply with an AT2005B PWM controller to output a higher voltage on the +12v rail.
I attached an image file I found on an old thread from another forum, and my question is if I need to lift pins 2, 3, 4, 5 and 6 before soldering those pots.
Will it also increase the +5v rail's voltage? And why?
Thanks for any help I can get.
I attached an image file I found on an old thread from another forum, and my question is if I need to lift pins 2, 3, 4, 5 and 6 before soldering those pots.
Will it also increase the +5v rail's voltage? And why?
Thanks for any help I can get.
Comment