So 2 years ago a surge hit this monitor:/ which years before i got it going again replacing the 2 16v caps on the main board C80 and C83.
After the surge all i had was a black screen with a blue led than it goes orange after secs.
So i took it apart to check it which i didint find no issues.. But my dam luck a screw driver drop on the psu and big spark happen and it blew the small 250v box fuse.
So it sat for a year till i ordered new fuses on amazon 2 days ago and got them in yesterday.
So i took it apart replaced the fuse and it has power again but just a blue light and you can see blinking on the black screen but no black light.
So what i did was get a hair dryer and heat up the main board were the caps i replaced years ago ago when i had fuzzyness and the controls was wonky and tried turning it on and bang the black light comes on and its stuck in a self color mode test going from rgb and greys and repeats ?
it detects the pc and the pc detects it cause it stays on but asoon as you disconnect it from the pc it will stay on for 5secs than go in standby.
What will cause this issue? i tried replacing the 2 caps with ones i had on a bad motherboard too see if it does anything but nope.. the caps are the C80 and C83 ones which i replace the ones i had on it which was 120uf 16v with 100uf 16v.
Now what i do noticed is the main board runs hot to the touch c80 and c83 is pretty hot and the middle chip burns you finger so im not sure if thats normal or what?
After the surge all i had was a black screen with a blue led than it goes orange after secs.
So i took it apart to check it which i didint find no issues.. But my dam luck a screw driver drop on the psu and big spark happen and it blew the small 250v box fuse.
So it sat for a year till i ordered new fuses on amazon 2 days ago and got them in yesterday.
So i took it apart replaced the fuse and it has power again but just a blue light and you can see blinking on the black screen but no black light.
So what i did was get a hair dryer and heat up the main board were the caps i replaced years ago ago when i had fuzzyness and the controls was wonky and tried turning it on and bang the black light comes on and its stuck in a self color mode test going from rgb and greys and repeats ?
it detects the pc and the pc detects it cause it stays on but asoon as you disconnect it from the pc it will stay on for 5secs than go in standby.
What will cause this issue? i tried replacing the 2 caps with ones i had on a bad motherboard too see if it does anything but nope.. the caps are the C80 and C83 ones which i replace the ones i had on it which was 120uf 16v with 100uf 16v.
Now what i do noticed is the main board runs hot to the touch c80 and c83 is pretty hot and the middle chip burns you finger so im not sure if thats normal or what?
Comment