Hello everybody. I have an issue with broken bulged caps with my evga 680i sli mobo and i could need any help.
My motherboard is in attachment and i need recapping of the following caps :
1. 2x rubys MFZ 6.3v 2700uf 10mm diameter (light green rectangle)
2. 4x rubys MCZ 16v 1800uf 10mm diameter (red circles)
3. 4x samxon GC 6.3v 1500uf (light blue rectangle)
(i already read about high ripple and very low esr on both rubys)
I think that something went wrong with temperature because few weeks earlier my northbridge cooler stopped. So this is probably the reason of bulging.
Nowadays there are not compatible electrolytics for the rubys (neither in digikey, mouser or here) so i can guess polys is what i have to place, but i dont know what series or capacitance.
Any help would be appreciated.
My motherboard is in attachment and i need recapping of the following caps :
1. 2x rubys MFZ 6.3v 2700uf 10mm diameter (light green rectangle)
2. 4x rubys MCZ 16v 1800uf 10mm diameter (red circles)
3. 4x samxon GC 6.3v 1500uf (light blue rectangle)
(i already read about high ripple and very low esr on both rubys)
I think that something went wrong with temperature because few weeks earlier my northbridge cooler stopped. So this is probably the reason of bulging.
Nowadays there are not compatible electrolytics for the rubys (neither in digikey, mouser or here) so i can guess polys is what i have to place, but i dont know what series or capacitance.
Any help would be appreciated.
Comment