Vestel 17IPS10-3 v1 with 17MB62-1 - Standby Problem - blinking 3 times
Hi,
I've repaired some smaller vestel TVs already, with replacing some diodes.
Right now I'm not able to repair a TELEFUNKEN TF32EP843 FHD DVB-T.
It consists of a 17IPS10-3 v1 and 17MB62-1 v1.
When I turn on the TV, the standby LED constantly blinks 3 times.
I'm able to "start" the TV by holding on/off button on the RC. Than it can be normally used.
But when switching it off, it begins blinking again. I attach the log from Putty to this thread.
Can anyone suggest how to repair it? The diodes I checked already.
5v from PSU has 5,33v
3v from PSU has 3,43v
12v from PSU has 11,32v
I'm not familar how the standby works between PSU and Mainboard. I'm not able to read the schematic
When I update the firmware (only when updating) this is displayed:
#
UART_115200
BIST0-OK
BIST1-FAIL
#
Thanks
Stephan
I've repaired some smaller vestel TVs already, with replacing some diodes.
Right now I'm not able to repair a TELEFUNKEN TF32EP843 FHD DVB-T.
It consists of a 17IPS10-3 v1 and 17MB62-1 v1.
When I turn on the TV, the standby LED constantly blinks 3 times.
I'm able to "start" the TV by holding on/off button on the RC. Than it can be normally used.
But when switching it off, it begins blinking again. I attach the log from Putty to this thread.
Can anyone suggest how to repair it? The diodes I checked already.
5v from PSU has 5,33v
3v from PSU has 3,43v
12v from PSU has 11,32v
I'm not familar how the standby works between PSU and Mainboard. I'm not able to read the schematic
When I update the firmware (only when updating) this is displayed:
#
UART_115200
BIST0-OK
BIST1-FAIL
#
Thanks
Stephan
Attached Files