Re: Vizio E371 Completely Dead
To BUDM: PS_ON is [U]not [/U]functioning via the video board. Video board was disconnected -- I turned the 12v bus and inverter trigger on manually at the power suppy.
I'd really like to run this down -- lost without schematic Re: Vizio E371 Completely Dead
To BUDM: PS_ON is [U]not [/U]functioning via the video board. Video board was disconnected -- I turned the 12v bus and inverter trigger on manually at the power suppy.
I'd really like to run this down -- lost without schematic Re: Vizio E371 Completely
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Vizio E371 Completely Dead
The power board checks out OK (380 volts across capacitor) - problem is no turn-on signal from the video board. Can anyone help with a schematic or circuit description for this board? Does EPROM control feedback to power board? Since we're not getting amber logo on startup, I'd like to focus on the components that trigger turn-on signal.
Ideas welcome :-)
Leave a comment:
-
Re: Vizio E371 Completely Dead
On the main board I read 5.1 volts both sides FP1, and 5 mV both sides on FP2 (should be 12 v). Obviously the video board is not turning on the 12v supply. As mentioned the power supply outputs 12v when triggering it alone via on-off pins (3 and 4)
Leave a comment:
-
Re: Vizio E371 Completely Dead
No difference: cold start 82.3 degrees, plug in power, temp stays @ 82.3
Leave a comment:
-
Vizio E371 Completely Dead
No amber Vizio, LCD TV completely dead.
Power supply outputs 5v, outputs 12v and inverter backlights when pins 3 & 4 supplied 5 v via 100 ohm resistors with voltage & video board disconnected. Power supply OK?
All fuses on both boards OK, caps look OK, could only find 2 regulators on video board (UP3 UP13) both have extremely low voltage (165 mV in .8mV out)
Any ideas how to proceed?...
No activity results to display
Show More
Leave a comment: