Re: Vizio Plasma P50HDM Posterized & washed out color and flicker
OK, I was able to adjust the Vsc to 115v by turning the VSET_DN trim all the way down (counterclockwise) and turning the RAMP_UP all the way up. Turning these trims had mostly no effect on the -Vy (-185 to -189). Turning the VSET_UP either way had no effect on either Vsc or -Vy. Visually I don't see any evidence of an IC failure and all fuses I could see checked good. It appears the Y-Sus fails on these TVs so I should probably pull the board out and remove the heat sinks for better inspection. I don't have a...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Vizio Plasma P50HDM Posterized & washed out color and flicker
I adjusted the Vs from 185V to 196V and the Z bias from 98V to 100V. That appeared to eliminate the flicker but not the bad image. I attempted to adjust the Vy and Vsc with trim pots but couldn't get both dialed in to suggested voltages. I did adjust these while viewing and it appears to change contrast and brightness but the grainy posterized image didn't improve. I'm posting a pic of the board that I adjusted voltages and the TV image so you might have a better idea of what I'm adjusting and what the image appears...
Leave a comment:
-
Re: Vizio Plasma P50HDM Posterized & washed out color and flicker
Ok, Seems my DMM batteries were dying so some of these readings were off.
Now my readings are:
Z bias: 98.9v
Vsc: -108v
Vy: -185v
Vs: 187.0
Vy:59.1
I do see what appears to be a Vs adjustment trim pot that's labeled "Vs-adj VR201" on the power supply board. Not sure if the 201 is a target voltage. I don't see any other labeled voltages for Vs and -Vy on the board I checked those voltages.
MorebassLast edited by Morebass; 11-06-2013, 02:58 PM.
Leave a comment:
-
Vizio Plasma P50HDM Posterized & washed out color and flicker
Vizio Plasma TV
Model# - P50HDM
MFR date: 6/2005
Screen: LG PDP50X3002142.ASLGA AB
I recently acquired this tv and after initial startup the picture appeared washed out, posterized and grainy. I visually inspected all caps and none appeared bad. Onboard fuses (2) checked good. After plugging the tv back in the picture now appears to have developed a flicker. Problem was the same fed through HDMI or analog. Did a factory reset with no change.
With DMM I probed the following:
Z bias: 98v
Vsc: 113v
Vy: 125v
Any suggestions?...
No activity results to display
Show More
Leave a comment: