Re: Baird X37DTV stobe Backlight issue

i was going to reply much earlier, but i had a visitor.
the current cap is 1500uf 16v, it should be a 1000uf 16v.

i actually heat the set up at the 150uF 400v for the voltage to stabilise, which i presume is the primary side.

Re: Baird X37DTV stobe Backlight issue

Does anyone know who actually makes this set? or where i can find the schematics for the PSU? I've replaced the "Large Cap" 150uF 400v and measuring the 12v line when cold i get 10.5v as it warms up the voltage goes towards 12v the strobing gets faster until it eventually stops and then displays a lovely picture.

I've seen the Bauer xt37 mentioned with this PSU but can't find any diagrams on that either.

what would be the effect of using a 1500uF in place of a 1000uF (same Voltage spec) on the 12v line? The...

Re: Baird X37DTV stobe Backlight issue

thanks for this info, i have same problem exactly on a baird x42, the youtube vid is the exact fault... i have just ordered the cap to repair, i'm feeling confident thanks again!