NO Green Light neither Orange light. Due to fungus the R5100 was bad. SMC_RESET_L pin is okay of the resistor but the PP3V42_G3H track gone. So I have to connect by jumper wire with the 100K.
After that the adapter light is on, first green to orange. Motherboard fan starts to spin. All the power supply voltage is there. But No Display. And I also noticed that after 20 to 30 seconds the MB restarts and gradually FAN Speed increasing. BUt NO Display.
But interesting part is that after replacing the R5100 the display have come two/three times. So I have tried ME clean,...
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
-
820-2936 B not turning on with adaptor.
Not turning on with adaptor but with battery the laptop is turning on,.
And also battery is not charging. I changed the PU7000. PU7000 pin no 14 is 3.3V.
now what should i check?
GREEN LIGHT of mega Safe is there.
-
Re: Acer e5 573g 380S || DA0ZRTMB6D0 Bios Needed.
Da0zrtmb6d0 rev: D
-
Acer e5 573g DA0ZRTMB6D0 Bios Needed.
DA0ZRTMB6D0 REV Can anyone provide me the bios of this board.
-
Re: Lenovo All in One C260 bios dump
thanks mate. it worked for me.
Leave a comment:
-
asus x202e schematic needed. NO INTERNAL DISPLAY.
I have this mb. the external display is ok but there is no internal display. can anyone have that schematic?
Leave a comment:
-
ga-h61m-s1 motherboard schematic needed.
I need the schematic of following gigabyte MB [B]ga-h61m-s1[/B]. the MB switching off immediately after turning on from Front panel switch.
thanks in advanced.I need the schematic of following gigabyte MB [B]ga-h61m-s1[/B]. the MB switching off immediately after turning on from Front panel switch.
thanks in advanced.I need the schematic of following gigabyte MB [B]ga-h61m-s1[/B]. the MB switching off immediately after turning on from Front panel switch.
thanks in advanced.
-
[B]WISTRON HM42-CP JE40-CP 48.4GW01.011 09920-1 REV SC - ASPIRE 4741ZG[/B]
[URL="http://**************/load/noutbuki/platforma_wistron/wistron_hm42_cp_je40_cp_rev_sc/315-1-0-21710"]http://**************/load/noutbuki/platforma_wistron/wistron_hm42_cp_je40_cp_rev_sc/315-1-0-21710[/URL]
[B]WISTRON HM42-CP JE40-CP 09920-1 - BoardView (.BRD)[/B]
[URL="http://**************/load/noutbuki/platforma_wistron/wistron_hm42_cp_je40_cp_09920_1_boardview/315-1-0-28428"]http://**************/load/noutbuki/platforma_wistron/wistron_hm42_cp_je40_cp_09920_1_boardview/3...
-
Acer Travelmate 4740 schematic needed.
schematic needed for acer Travelmate 4740.
here is the part no.
09920-3
JE40-CP MB
48.4GY02.031
-
NEED THE FULL DETAILS OF TPS 51621 IMVP Mobile Processors POWER SUPPLY
NEED THE FULL DETAILS OF [B]TPS 51621[/B] IMVP Mobile Processors POWER SUPPLY.NEED THE FULL DETAILS OF [B]TPS 51621[/B] IMVP Mobile Processors POWER SUPPLY.NEED THE FULL DETAILS OF [B]TPS 51621[/B] IMVP Mobile Processors POWER SUPPLY.
-
Re: LENOVO THINKPAD L430 schematic needed.
The Enable signal is going off after some time of Adaptor is inserted on the motherboard. And it also goes off from GPIO34 (Pin14) at same time....
Leave a comment:
-
Re: LENOVO THINKPAD L430 schematic needed.
thanks a lot, I'll look through the MB by schematic now....
Leave a comment:
-
LENOVO THINKPAD L430 schematic needed.
Does anyone have the schematic of LENOVO THINKPAD L430 motherboard?
The laptop is now totally dead. no switch on. also the standby voltage missing.
Here is the part no.
[B]LCD-1 MB
11248-4
48.4SE04.041[/B]Does anyone have the schematic of LENOVO THINKPAD L430 motherboard?
The laptop is now totally dead. no switch on. also the standby voltage missing.
Here is the part no.
[B]LCD-1 MB
11248-4
48.4SE04.041[/B]
-
Re: IEL10 LA-3451P REV:1.0 No switching,
plz anyone, do you have any suggestion?
thanks.
Leave a comment:
-
IEL10 LA-3451P REV:1.0 No switching,
Information about the MB:
3.3V = ok;
5v = ok;
switching voltage = ok;
I have also flushed the bios. But the board [B]completely dead[/B]. I ahve also checked the RTC Crystal frequency which is OK. [B]The board refuses to switch on.[/B]
I need your experienced suggestion on this matter.Information about the MB:
3.3V = ok;
5v = ok;
switching voltage = ok;
I have also flushed the bios. But the board [B]completely dead[/B]. I ahve also checked the RTC Crystal frequency which is OK. [B]The board refuses to switch on.[/B]
No activity results to display
Show More
Leave a comment: