Re: 19" General touch monitor
I do know that the inverter and the a/d board are good (I think) because they are brand new exact replacements.
pinball1
Member
Last Activity: 05-02-2018, 10:52 PM
Joined: 03-09-2006
Location:
-
Re: 19" General touch monitor
So can you explain to me why I get no flash when I plug individual bulbs into the inverter board. I do get 2 seconds when I plug 2 bulbs in.Leave a comment:
-
Re: 19" General touch monitor
Am I understanding that a single bad ccfl can cause the inverter board to shut down hence the 2 seconds then black.Leave a comment:
-
Re: 19" General touch monitor
Here you go...Leave a comment:
-
Re: 19" General touch monitor
Removing 3 of the inverter connections and leaving one attached I don't seem to get any flash. Tried all 4, one at a time.
It I leave two on either end connected. I get the 2 seconds and black.
I guess part of my confusion is that after replacing both the a/d board and the inverter board and still having the 2 seconds then blank. I didn't think a cfl problem would do this.Leave a comment:
-
19" General touch monitor
I have a 19" General Touch monitor that does the 2 seconds then black thing.
The monitor only has 2 boards. An A/D-logic board and an inverter board.
I have replaced both boards with new ones and I still have 2 seconds then black.
Reading the sticky I'm not sure how to test the cfl's. The inverter board has 4 2 pin conectors. Do each of these power 1 lamp? Can all 4 of my lamps be bad?
Sorry if these are dumb questions, I have very little experience with LCD monitors. -
Re: Canadian Shipments Suspended
Certain government employees should not......and cannot strike.
Remember the air traffic controllers during the Reagan addministration.
Some government jobs are so important to our countries commerce, we cannot afford to allow strikes.
Those are the rules....don't like it......don't take the job.Leave a comment:
-
Dead Emachine T3624
My daughters (less than 2 year old) T3624 e-machine died. Opened it up...caps all look good. One green led on the MOBO lights when you fire it up. Hooked up my power supply tester. Tested good. Maybe it's the main switch. Pulled the switch connector and shorted with a screwdriver. Nothing.....Then I googled and started to read. Seems this motherboard may have some problems, but the bestec PS seems to be the main reason for failures.
Is there any hope of bringing this MOBO back to life. My concern is, if I buy a replacement MOBO, how much trouble will I have with winxp on her hard drive... -
Re: Mul-3333?
$50. It's described as an ESR tester. Electrolytic capacitor in circuit tester.
Think I've been had????Leave a comment:
-
Re: Mul-3333?
I just bought one that was made for Matt electronics. The exact same meter you pictured. It came with one page of instructions. They sound like they were written by someone with very limited english skills (MIC). They tell you how to put the batteries in....that's about it. They don't even tell which of the two plugs is + and which one is - . After googleing around I found a pic. of one with the + (red) probe plugged into the hole nearest the on/off switch.
Now....if I just knew how to use the damn thing.
I've been googling around esr manuals...Leave a comment:
No activity results to display
Leave a comment: