Re: Onkyo TX-SR606
What was the initial problem ? is it no sound?...
srt1
Senior Member
Last Activity: 05-21-2023, 01:55 AM
Joined: 08-16-2013
Location: calicut
-
Re: pioneer vsx 2021 no sound
[url]http://smanuals.ru/manuals/home-theater-reciver/home-theater-reciver-pioneer/pioneer-vsx-53-1326.html[/url]Re: pioneer vsx 2021 no sound<br /> ...326.html[/url]...Leave a comment:
-
Diiference between d80yk113cptp4 and d808k013cptp400
what is the difference between above two dts chip? d80yk113cptp4 is using in yamaha and d808k013cptp400 using in onkyo and pioneer receivers , when i check pin configuration both are same, -
Re: pioneer vsx 2021 no sound
what is the damage? no sound? yes i have service manual.i will upload here...Leave a comment:
-
Re: Harman Kardon AVR 141 protect mode and volume issue
CHECK THE output volatge on speaker terminal before protect mode appear...Leave a comment:
-
Re: Onkyo tx sr 607 -New DSP chip installed
What you mean...Leave a comment:
-
Re: Yamaha RX-V675, No sound
Any one can help me , what i do next?...Leave a comment:
-
Re: Yamaha RX-V675, No sound
Hii i replced the dsp chip but still no sound ,when i am updating firmware its failing and showing error code 0010 also i check in daignostic menu its showing dsp bus NG ,same as before..what will be the couseLeave a comment:
-
Re: Onkyo tx sr 607 -New DSP chip installed
no other bga related to sound processing . my problem was bad soldering of dts chip .....Leave a comment:
-
Re: Onkyo tx sr 607 -New DSP chip installed
i think your DSP is BGA right?.. in TX SR607 not BGA, ok do soldering and and let me know the result,Leave a comment:
-
Re: Onkyo tx sr 607 -New DSP chip installed
Hi ,,, i sort out the problem now .. the problem wass improper soldering ,, one pin of DSP chip ws not solderd properly ,,i soldered it again now its ok:musics
i reach a conclusion now ,, there is no flash rom inside the DSP chip itselfLeave a comment:
-
Re: Onkyo tx sr 607 -New DSP chip installed
what will be the cause for itLeave a comment:
-
Re: Onkyo tx sr 607 -New DSP chip installed
HI... good news.. i kept in on condition this onkyo more than two hours after that i just checked the dsp firmware version ,,, success in display its shwoing the version.. but i dont know how it came..i connected speakers and i got sound,, but i restarted the again but its gone.. again display shows bunch of questions mark in dsp firmware.. but now i am kept it on conditionLeave a comment:
-
Re: Onkyo tx sr 607 -New DSP chip installed
DSP Chip itself have internal ROM? .. i saw a NAND flash ic near by itLeave a comment:
-
Onkyo tx sr 607 -New DSP chip installed
Hi i recently got Onkyo rx sr607, the problem was it have no sound even in any mode, then i checked the DSP chip, i found that it getting very hot, so i suspect there some internal short inside, I ordered new chip same part number and i replaced yesterday, But sill have no sound , i checked the voltage rail it is in limit as per schematic 1.2 volt and 3.3 volt. but when i am checking the DSP version on Display its showing D: ??/ ????????? like that .. i will appreciate anyone help on this -
Re: Harman Kardan AVR 141 protect mode and volume issue
HI, I replaced C3200 with C1845, now amplifier section is ok.. but i want fix the volume issue on Surround right channel.Leave a comment:
-
Re: Yamaha RX-V675, No sound
DTS chip number is D80YK113CPTP4 . is this ic also premature failing as in onkyo?Leave a comment:
-
Re: Yamaha RX-V675, No sound
But how i confirm dts chip already failed.if it failed i want replce itLeave a comment:
-
Re: Harman Kardan AVR 141 protect mode and volume issue
i need help regarding the volume issue also.. if it faulty NJW1197 ic , i want divert the audio signal to other channel which is unused as this ic has 8 channel volume control is ther now only its 6 channel used ,,hope i can use one channel out of 2 in remaining , but i dont know how to configure it..Leave a comment:
-
Re: Yamaha RX-V675, No sound
I tried everything.. i am getting sound only when i am connecting analog signal in pure direct mode.. in any dsp mode no sound coming.. also i tried rest, after that i tried to upgrade firmware but its always failing..Leave a comment:
No activity results to display
Leave a comment: