Re: sony tv kdl 46 xbr2 no video or sound
No backlight, no picture, no audio, but green light solid lit.,
when this happens the problem can be caused by the au board, the tcon, and the be2 board. The trick is to look for a heartbeat led on the be2 board. If no heartbeat led on be2, it is the most likely cause. Good luck. I pulled my hair out on this. I had tried an au board and a tcon board.
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: KDL-55NX720 Pwr Led Blinks 5 times
Service manual for 5 blinks is t-con error/panel ID NVM error. T-com control MT board.
Leave a comment:
-
Re: Board Needed for Mitsubishi LT-55154
Have you tried Shop Jimmy.com ?
Leave a comment:
-
Re: TV Sony NSX-40GT1 (Power Supply)
dead and 2 blinks.....REPLACED SHORTED FETS Q6101 & Q6102 (2SK4084) WITH (2SK3563) AND REPL OPEN RESISTER R6536 WITH .47 1/2 WATT SONY PN 1-220-926-21.. SAVED NEEDING TO REPLACE THE SMPS
Leave a comment:
-
Re: Fuzzy audio.
I believe this is a software update problem. support.toshiba.com/support/modelHome?freeText=2805249.
Leave a comment:
-
Re: Sharp LC-60LE640U 1 long, 1 short blink
I was able to force the set on using sharps force on procedure for this model which is to unplug the set from ac simutanously press and hold ch down & vol up down and while holding buttons down, plug set into ac,
Leave a comment:
-
Re: Mitsubishi WS-65611 projection tv won't power on
dead - no blinks----CHECK 12V [AC-OFF DETECT] PIN 3 PC9A21. IF MISSING REPLACE PC9A21 268P058020 ON THE POWER PCB. 2] CHECK FOR 5V AT CONNECTOR RF PIN 3 [SYSTEM RESET] IF LOW OR MISSING THE RESET SWITCH S7L20 432P089010 ON THE CONTROL PCB.
dead - no power----CHECK TAC SWITCH PANEL FRONT, REPLACED.
Leave a comment:
-
Re: Sony KV-36FV310
If you need the service manual e-mail me at [email]curt.wolfe@gmail.com[/email]Re: Sony KV-36FV310<br /> <br /> I...il.com[/email]
Leave a comment:
-
Re: Sony KDL-32L5000 No Power
No secondary voltages and no 3.5v standby. Unplugged h2 module, leds, ir receiver and 3.5v came up. Found c9101 shorted on h2 board.10mfd/10v smd. Also check c9113 t
Leave a comment:
-
Re: Sony KDL-46EX500 - Black Screen & No Sound
The main would send the power-on voltage to the power supply and the ps would come up, but then the main would not send the other turn on voltages to the ps, the inverter-on and t-con-on. After changing the main and power boards it turned out to be an intermittent problem with the ir board.
Leave a comment:
-
Re: Sony KDF-46E3000 dark picture
If not the lamp it will be the light engine.
Leave a comment:
-
Re: SAMSUNG UN46D6420UFXZA bad t-con
Have you tried "shopjimmy.com" ?
Leave a comment:
-
Re: Mitsubishi WD-82837 Software
If I were you I would do the software V41+_11_03. It could be that the software update will take care of the problem your having. Make sure you format the stick to FAT32 before you down load the software to the stick.
Leave a comment:
-
-
Re: Element elefw502 firmware issue
Sorry, someone gave me it and said it had firmware updates.
Leave a comment:
-
Re: Element elefw502 firmware issue
Element: [url]http://www.elementelectronics.com/support/[/url]Re: Element elefw502 firmware issue<...support/[/url]
Leave a comment:
-
Re: Seiki SE50FY28 No Video Power Control Board mixed up
Seiki: [url]http://www.seikidigital.com/support/downloads.php[/url]Re: Seiki SE50FY28 No Video Power Co...oads.php[/url]
Leave a comment:
-
Re: Sanyo DP26648 Only Backlight
Replace ribbon cable connecting panel to the t-con board # n6ce ffc. Common problem with this set.
Leave a comment:
No activity results to display
Show More
Leave a comment: