Re: help with 42v7 plasma tv
thanks
Iwill get the IPM ordered and hope everything goes as planned.
again thanks for you help:P
kind regards
Mike.
mkeen
New Member
Last Activity: 12-30-2013, 08:55 AM
Joined: 06-11-2013
Location: wolverhampton
-
Re: help with 42v7 plasma tv
VS to GND is now open
my IPM is STK795-811a 6IBLN
but i can only find the STK795-811a 6IBDK
would it be ok to use this one?
or do i have to have exact match?Leave a comment:
-
Re: help with 42v7 plasma tv
I have managed to de-solder the IPM.
so i will order a new one sometime next week
hopefully it will solve my problem.Leave a comment:
-
Re: help with 42v7 plasma tv
ok then i will try my best to get a replacement board
thank you very much for your help
kind regards
mikeLeave a comment:
-
Re: help with 42v7 plasma tv
thanks
the tip by me don't let you take anything of site
what wattage iron would you recommend as i will try do desolder and replace the IPM
before i try to source a replacement board.Leave a comment:
-
Re: help with 42v7 plasma tv
thanks
i just checked it shows 1 ohms on my cheap dmm.
so does this mean the chip is fried?Leave a comment:
-
help with 42v7 plasma tv
hello
I have been given a faulty 42v7 plasma tv and i was hoping i could repair it with minimal cash spent as I'm a bit poor at the moment
the cause of the fault is the owner tried to adjust the set up /set dwn whilst the cover was still on he said there was a spark and it switched off.
i took the cover of to find that he had shorted a cap to the case
as there was large mark on the cap.
so i replaced the cap and the blown fuse on the ysus board
and the tv will switch on then off after a couple of seconds
I disconnected... -
Re: New Members - please post your introductions here
hi
my name is mike I'm an amateur electronic hobbyist.
i joined here to get help with repairing a plasma tv.Leave a comment:
No activity results to display
Leave a comment: