Re: Beko Z1.194-06 PSU



Sorry for delay

I see, so perhaps a partial short or a breakdown in resistance on the main board could be causing the 12V rail to increase to 15V to maintain the subsequent rise in current.

The PSU capacitor brand is G-LUXON...

Re: Beko Z1.194-06 PSU

Yes thanks for that but I am more concerned about the PSU first because it is putting out 15V where as far as I can tell it should be 12V. This over voltage may be the cause of the failed caps. So far I have tested all the "passives": electrolytics, resistors and diodes on the PSU all seemingly good.

I have been given an OKI LCD TV that is faulty the guy was going to throw it away because someone told him it needed a new power supply. I have powered it up and right enough it does not seem to come on and the power led on the front panel remains red. However, after a few minutes the tv displays "P 50" in the top right of the screen. not sure what that means? Page 50 of the manual perhaps or maybe an error code. At least it proves that the screen and video processor are working I suppose.

I have removed the back and inside the main board is a [B]BEKO Z1J19or-08[/B] and...