Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
petttu
Member
Last Activity: 05-18-2018, 03:08 PM
Joined: 05-05-2013
Location: Kuopio
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Re: Phillips 55PFL6007T/12 no picture

    Hey, I checked the fuses, t-con board got 8,2v at both sides (it should be 12v?). Also, I checked the Mainboards fuse that is near the lvds cable, on the feed I got 12v but at the output only 8,2v. Then when I disconnected the lvds cables and started the tv I got 12v on both sides in the mainboard.
    At first, I measured both fuses look ok by the diode meter, but because it was losing voltages a checked them again and now the Mainboards fuse has around 500ohms and the t-con board has near 0 ohms. I will try to change the mainboards fuse,...
    See more | Go to post

    Leave a comment:


  • Phillips 55PFL6007T/12 no picture

    I bought this broken tv ( Phillips 55PFL6007T/12 ). With a fault of not turning on, and at the time I got it, it would not react to anything (no lights nothing).
    So, I opened it up and focused with the power strip for the power supply to SSB, there was no contact at fin of the pins, so I just soldered the cable straight to the board. Power supply's voltages were all good.
    After that I got it to start, only to notice that there was no picture, back light worked property (when I changed channels it dimmed for a split second).
    And it would not stay on for more than a 5-10...
    See more | Go to post

  • Re: Sony Bravia KDL-46W5500 no picture or sound

    jpalmeida; well no, nothing new. I am focusing to the power board next

    budm: thats not the solution, because the inverter/balancer board has no voltage in the high voltage section
    See more | Go to post

    Leave a comment:


  • Sony Bravia KDL-46W5500 no picture or sound

    So I got from a friend this bravia, with a fault that it has no picture. The green led comes on, but no backlight or sound. After a minute or so it shuts down and starts blinking red led(first 1 time then a second delay then 13 times and a second delay, and then it starts blinking 14 times with a one second delay at a loop). So I have taken the back cover off and measured the voltages of the main board(though the error code suggest t-con, panel or inverter/balancer?).

    In CN6150 (Mainboard) and CN6151 (T-con) everything is ok, but CN6701(inverter) the FB(feedback?) lines are at...
    See more | Go to post

  • Re: New Members - please post your introductions here

    Hi all, greetings from Finland.
    See more | Go to post

    Leave a comment:

No activity results to display
Show More
Working...
X