Re: Teac CD PD-H400 Tray Opening Intermitantly
Thanks everybody, I will clean it,measure and replace and let you know the outcome
Philip
Wishiknewmore
Member
Last Activity: 12-12-2016, 04:15 PM
Joined: 03-28-2013
Location: Durham
-
Re: Teac CD PD-H400 Tray Opening Intermitantly
See attached best photos I can do
I would not describe as tight as there is not a straight line --it seems to bow a little
suggestions?
Thank you...Leave a comment:
-
Re: Teac CD PD-H400 Tray Opening Intermitantly
Thanks
I can see it now
It is still intact but I assume that it is worn/perished/stretched
Any suggestions how I determine the correct size?
Many thanks
PhilipLeave a comment:
-
Re: Teac CD PD-H400 Tray Opening Intermitantly
I was going to say no,but I have just been playing with it far the last 10 mins and it worked repeatedly for about 25 times then stopped and when trying there is a very short run of a motor
I don't immediately see any belts ...lots of geared wheels and toothed racks
It is quiet a sizeable and well built looking mechanism, but I have yet to take it out of its chassis/case
I find it strange that it works immediately after a reconnecting the power as if it has rebooted or something
...Leave a comment:
-
Teac CD PD-H400 Tray Opening Intermitantly
Hello
I have just "inherited" a Teac CD player because the drawer will not open, I have just opened it up and place a CD in and the machine seems to work OK except for the drawer
On pressing the open/close button it can work repeatedly then 10 minutes later it wont!
When it works, it works well, not stiff or sticking
Unplugging and re-plugging seems to fix the problem ---for a while!
I am very much an newbie on this stuff so may have missed something very obvious
Give me a clue!
Many thanks in anticipation... -
Re: Technika LCD 19 DVDID-208 (Vestel)
Selldoor
I have done as you suggested checked voltage regulators and they appear to be close to spec and then fitted a car an inline 5 amp car fuse and it has sprung into life
Many thanks
I still have a problem with some of the logic of setting it up without the remote and the DVD still seems dead, but it is very good to see a picture on it
Thanks againLeave a comment:
-
Re: Technika LCD 19 DVDID-208 (Vestel)
Selldoor
Thanks for your very quick reply, I am fairly happy about the polarity of the capacitors as I was very careful when fitting
The leads I believe that they are in the correct sockets, as I had thought of this and for the ones that I have taken off there does not appear to be another option - but any suggestions appreciated
BUT
I have just tested the fuse and it is open and there is 12.2v on one side and (obviously I believe) 0 on the other
Suggestions?
Thanks againLeave a comment:
-
Technika LCD 19 DVDID-208 (Vestel)
Hello
Re Technika - inexpensive non working 19inch dvd tv lcd combo ( I believe it is made by Vestel)
I have a flat screen tv and thought that I would have an attempt at fixing it
Symptoms - no life whatsoever except for the standby light which went from red to green when the power button is operated
My naive diagnosis was that it must be the power supply,,, therefore rushed out and ordered set of capacitors ( all 4 of the output ones) 3 had been replaced a couple of years ago - but bought all 4 plus there are two on the inverter board...
No activity results to display
Leave a comment: